1. Looks like the 3.5″ drive I have is broken – I held on to it to be able to reformat the 2 TB 2.5″ drive I have which has all my blu-rays on. I could prolly do a bad block scan… …only it would literally take *days*, and I don’t want that much noise 24/7 in my room next to me while I work! Still, it’s far better THIS than the other drive, ’cause then I would have lost data. Most of the blu-rays are in storage and so not accessable.

2. libmpfr 2.4.2, the recommended version for GCC, is broken on MIPS. Go figure. There’s a patch, I’ve applied it.

3. I discovered after playing around with a USB voltage/amps meter that the four-port synwire USB charger I use to power my dev boards and wifi router instead of having four 2.4 amp ports, as I had thought, in fact has two 2.4 amp ports and two 1 amp ports. This is why the ci20 kept bloody crashing. I’ve ordered a decent Anker unit, with six ports. Anker are right now AFAIK the best USB equipment manufacturer.

4. The PINE64 turns out to have major ethernet issues. I downloaded a benchmark app. It normally runs at about 90mbit (the hub is 100mbit) but every few seconds drops down to zero for three or four seconds. Googling finds a lot of people complaining about this. However, I also now find it’s just playing up completely, and right now, I can’t connect to it at all. Wierd.

5. GMP 4.3.2 (the version recommended by GCC) has a subtle bug such that one of the GCC tests will spuriously fail. Allegedly this is for 4.8.0 and later, but I seem to have it with 4.5.4. What this means in fact is that make check on GCC *ALWAYS FAILS*.

I’ve been reflecting a bit about the GCC build system.

It seems to me there is a clear and fundamental difference between black box and white box systems. A black box system is operable only by its controls; you cannot look inside. A white box system can be operated by its controls, but you can also modify whats inside.

A build system should be a black box. It should be a *working* black box. The user operates it by the controls on the outside. The user has *no need* to modify – and so to have to learn HOW to modify – what’s inside the box.

If the user in fact must modify the insides of the box to make it work, then it is not a black box – in fact, the user is performing developmemt work. The system has been published in a state such that the controls on the outside are inadequate, for whatever reason, to make the system work. The user to use the system MUST learn how it works, so he can perform the necessary development work to make it work.

In the case of GCC, where the white box is extraordinarily complicated, depends on external libraries with their own issues, is barely documented and is buggy and the problems vary by platform, having to learn how to modify the system is a very high burden, in fact, almost insurmountable, and I would think often not *sensible* – the cost is much more than the benefit.